Arai VX-Pro4 Combat Off-Road Helmet

The peak of this helmet is 14mm longer and 5mm wider than the VX-PRO3. Larger relief ports allow more air to escape from under the larger peak to minimize lift/pulling at speed. The chin vent incorporates expanded mesh, moving it from the inside to the outside of the shell. This provides room to move the EPS chin liner forward, reducing crowding near the face. Chin vent utilizes a round, smooth mesh cap to resist snagging and digging. Easily removable with a single, breakaway screw. The Inner Mud Gate can be easily removed for increased airflow.

The liner components feature FCS cheek pads with a larger surface area that wraps under the jaw for more comfort. Removable, replaceable, washable neck roll pad, with 5mm peel away cheek pads and temple pads. Ventilation consists of six upper vents, upper and lower rear exhaust vent cowl designed to increase airflow and vacuum exhaust, vents that assist holding goggle straps in center position and not slide, as well as an upper rear exhaust vent set to accommodate all five shell sizes. Includes three basic chin intakes, two under peak intakes, six upper exhaust and two lower exhaust.

The eye port trim and material uses molded rubber trim across the top of the eye port, standoff ribs that reduce liner wear while increasing airflow, and molded goggle strap guides at either side of eye port trim.

• Red and black material accent colors for a tri-color interior
• Emergency Cheek Pad Removal strap label design for easier use; label acts as pull tab for strap
• Meets or exceeds Snell and D.O.T. standards